Romod I/O Modules SL

This library allows you to use Romod I/O devices from the manufacturer Romutec (www.romutec.de) via RS485 COM-Port on supported CODESYS PLC runtimes. The devices can be easily added to the device tree. The configuration of module specific parameters is done under the device parameters tab, without any programming requirements. All input/output variables can be mapped in the I/O-Mapping section.

Version: 
1.1.0.0  
Order number: 
2312000001
€50.00 plus VAT

/

Romod I/O Modules SL

This library allows you to use the Romod I/O modules 16DI, 8DO, 8DO-R, 4DO-R, 8AI and 8AO with supported CODESYS PLC runtimes. It requires a RS485 COM-Port interface and also a Modbus license (mostly included).
The devices can be added to the device tree and also be extended with various romod modules. Variables can be mapped to the program under the I/O-Mapping Tab.
All output modules are local override/indication devices, the state can be monitored and changed. If the device is local overrided/indicated, then it will be shown under the device tree.  
There is also a parameter settings window for each module. Different settings as slave-address, Bus-Timeout, send command or cycle request time can be configured under this section. Many specific I/O extended settings are also available for example: Negation, two-point-function, limiter, damped function etc. The analog input module allows you to select sensors as PT1000/100, Ni 1000, NTC 10k, etc.
The Romod-Master device is required for configuring the physical hardware COM-Port. Common serial settings can be configured there.
The Hardware modules can be decentral installed (for example in electrical distribution boards). Supported bus cable length for the devices is up to 3937 feet (based on the environmental conditions). Each device address is configurable with dip switches. Serial communication settings as baudrate don’t need to be configured, because the devices are supporting “Autobauding”. This feature is decreasing the fault-rate and also the installation time out of the field.
Please note: The modules don’t support real-time requirements.



Collapse

Programming System

CODESYS Development System V3.5.10.0

Target System

CODESYS Control V3.5.10.0

Supported Platforms / Devices

Tested devices: CODESYS Control Win V3, Raspberry Pi,

 

Notice: Use the project ‘Device Reader’ to find out the supported features of your device. ‘Device Reader’ is available for free in the CODESYS Store.

Additional Requirements

RS485 COM-Port (also possible with USB Com-Port adapter), Modbus RTU License

Restrictions

The modules don’t support real-time requirements. Maximum number of 30 romod slaves for each Romod-Master device.

Licensing

License activation optional on CODESYS Runtime Key or CODESYS Soft Key. Demomode for 30 minutes. License per runtime device necessary.

Required Accessory

Romod I/O modules from the the manufacturer Romutec (www.romutec.de)

 

Pfänder GmbH
Bachstraße 15
74585 Rot am See

Deutschland

Tel: +49 7958 98000

support@pfaender.de

You may also be interested in the following product(s)

MySQL Library SL

MySQL Library SL

€70.00 plus VAT
Add to My Wishlist

Screenshots

Write Your Own Review

Only registered users can write reviews. Please, log in or register